Kia Cee'd: Instrument cluster (Super vision) / Warnings and indicators (Instrument cluster)
All warning lights are checked by turning the ignition switch ON (do not start the engine). If any light that does not illuminate, we recommend that the system be checked by an authorized Kia dealer.
After starting the engine, check to make sure that all warning lights are off. If any are still on, this indicates a situation that needs attention.
The following warning and indicators are introduced in the previous pages.
- Automatic transaxle/Double clutch transmission shift lever indicator
- Manual transaxle shift indicator
- Parking assist warning (LCD display)
- Active ECO indicator
- Seat belt warning and chime light
- Air bag warning light
- Immobilizer indicator
- Tailgate open warning light
- Low fuel level warning
- Electronic Power Steering (EPS) system warning light
- Turn signal indicator lights
- Light on indicator
- Low Beam Indicator Light
- High beam indicator
- High beam assist indicator
- Adaptive Front Lighting System (AFLS) malfunction indicator
- Front fog light indicator
- Rear fog light indicator
- Parking brake & brake fluid warning
- Electronic Parking Brake (EPB) malfunction indicator
- Anti-lock brake system (ABS) warning light
- Electronic Stability Control (ESC) indicator
- ESC OFF indicator
- Auto stop indicator
- Cruise indicator
- Charging system warning light
- Tire Pressure Monitoring System (TPMS) indicator
- Engine oil pressure warning
- Engine oil level warning light
- Malfunction indicator lamp (MIL) (check engine light)
- Engine coolant temperature warning light
- Glow indicator (Diesel engine)
- Fuel filter warning light (Diesel engine)
For vehicle’s equipped with smart
key system
Key not in vehicle
If the smart key is not in the vehicle and
if any door is opened or closed with the
engine start/stop button in the ACC, ON,
or START position, the warning illuminates
on ...
Active ECO indicator
When the active ECO is operating the
ECO indicator illuminates green. For
more detailed information, refer to
"Active ECO" in chapter 5. ...
Other information:
: Programming the Garage Door Opener to Your Gate Opener Motor
Gate Operator / Canadian Programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate ...
Kia Cee'd JD Service Manual: Rear Door Trim Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
Be c ...
