
Parking brake warning
This light illuminates when the parking brake is applied with the ignition switch in the START or ON position. The warning light should go off when the parking brake is released.
Low brake fluid level warning
If the warning light remains on, it may indicate that the brake fluid level in the reservoir is low.
If the warning light remains on:
1. Drive carefully to the nearest safe location and stop your vehicle.
2. With the engine stopped, check the brake fluid level immediately and add fluid as required. Then check all brake components for fluid leaks.
3. Do not drive the vehicle if leaks are found, the warning light remains on or the brakes do not operate properly.We recommend that you contact an authorized Kia dealer.
Your vehicle is equipped with dual-diagonal braking systems. This means you still have braking on two wheels even if one of the dual systems should fail. With only one of the dual systems working, more than normal pedal travel and greater pedal pressure are required to stop the car. Also, the car will not stop in as short a distance with only a portion of the brake system working. If the brakes fail while you are driving, shift to a lower gear for additional engine braking and stop the car as soon as it is safe to do so.
To check bulb operation, check whether the parking brake and brake fluid warning light illuminates when the ignition switch is in the ON position.
WARNING
Driving the vehicle with a warning light on is dangerous. If the brake warning light remains on, we recommend that the system be checked by an authorized Kia dealer.
Rear fog light indicator
Electronic Parking Brake
(EPB) malfunction
indicatorKia Cee'd JD Owners Manual: Cruise Control system
■ Normal vision
■ Supervision
1. Cruise indicator
2. Cruise set indicator
The cruise control system allows you to
program the vehicle to maintain a constant
speed without pressing the accelerator
pedal.
This system is designed to function
above approximately 30 km/h (20 mph).
W ...
Kia Cee'd JD Service Manual: Power Seat Control Switch Repair procedures
Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch.
A : Power seat control switch
B : Lumbar support swi ...