Kia Cee'd: Warnings and indicators (Instrument cluster) / Glow indicator (Diesel engine)

The indicator light illuminates when the ignition switch is placed at the ON position. The engine can be started after the preheat indicator light goes off. The illuminating time varies with the water temperature, air temperature and battery condition.

✽ NOTICE

If the engine does not start within 10 seconds after the preheating is completed, turn the ignition key once more to the LOCK/OFF position for 10 seconds, and then to the ON position, in order to preheat again.

CAUTION

If the preheat indicator light continues to illuminate or flash on and off after the engine has warmed up or while driving, we recommend that the system be checked by an authorized Kia dealer.

Engine coolant temperature warning light
The warning light illuminates if the temperature of the engine coolant is above 120±3°C (248±5.4°F). Do not continue driving with an overheated engine. If your vehicle overheats, refer ...

Fuel filter warning light (Diesel engine)
This warning light illuminates for 3 seconds after the ignition switch is set to the ON position and then it will go out. If it lights up while the engine is running, it indicates that water ...

Other information:

Kia Cee'd Service Manual: Rear Cross Member Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

Kia Cee'd Service Manual: TPMS Receiver Schematic diagrams
Circuit Diagram Hamess Connector   Pin No. Discription 1 Battery ECU 2 Ignition ON 3 CAN_HIGH 4 CAN_LOW ...

© 2017-2019 www.kceed.com