Kia Cee'd: Cooling System / Water Temperature Control Assembly Repair procedures
| Removal and Installation |
| 1. |
Loosen the drain plug, and drain the engine coolant. Remove the radiator
cap to drain with speed.
|
| 2. |
Disconnect the battery negative terminal.
|
| 3. |
Remove the air cleaner assembly.
(Refer to Intake and exhaust system - "Air Cleaner")
|
| 4. |
Disconnect the water temperature sensor connector.
(Refer to Fuel System - "Engine Control System")
|
| 5. |
Disconnect the radiator upper hose.
|
| 6. |
Remove the heater hose.
|
| 7. |
Remove the water temperature control assembly (B) after disconnecting
the water hose (A).
|
| 8. |
Install in the reverse order of removal.
|
Water Temperature Control Assembly Components and components location
Components
1. Water temperature control
assembly
2. Water temperature sensor
3. Gasket
4. Water
5. Bypass hose
...
Water pump Components and components location
Components
1. Gasket
2. Water pump
3. Water pump pulley
...
Other information:
: How Does Blind Spot Information System Work. Blind Spot Information System Precautions. Blind Spot Information System Limitations
How Does Blind Spot Information System Work
Blind spot information system uses
sensors on both sides of your vehicle,
detecting rearward from the exterior
mirrors to approximately 13 ft (4 m)
beyond the rear bumper. The detection
area extends to approximately 59 ft (18 m)
beyond the rear bumpe ...
Kia Cee'd JD Service Manual: Rear Bumper beam Assembly Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
Use ...
