Kia Cee'd: Body Side Molding / Front Wheel Guard Repair procedures

Replacement
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips and screws, then remove the front wheel guard (A).

3.
Install in the reverse order of removal.
  
Replace any damaged clips.
Rear Spoiler Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Rear Wheel Guard Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Other information:

Kia Cee'd JD Service Manual: Knock Sensor (KS) Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold. (Refer to Engine Mechanical System - "Intake Manifold") 3. Dis ...

Kia Cee'd JD Service Manual: Input Speed Sensor 1 Description and operation
Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM). It provides important input information for electric control. The information is needed in all operations, i ...

© 2017-2020 www.kceed.com