Kia Cee'd: Body Side Molding / Rear Wheel Guard Repair procedures

Replacement
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Remove the rear tire.
2.
After loosening the mounting clips and nut, then remove the rear wheel guard (A).

3.
Install in the reverse order of removal.
  
Replace any damaged clips.
Front Wheel Guard Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Front Mud Guard Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Other information:

Kia Cee'd Service Manual: Rear Lower Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

Kia Cee'd Service Manual: Crankshaft Position Sensor (CKPS) Description and operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed in ladder fra ...

© 2017-2019 www.kceed.com