Kia Cee'd: What to do in an emergency / In case of an emergency while driving

Kia Cee'd JD Owners Manual / What to do in an emergency / In case of an emergency while driving

If the engine stalls at a crossroad or crossing

If you have a flat tire while driving

If a tire goes flat while you are driving:

1.Take your foot off the accelerator pedal and let the vehicle slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off the road as this may cause a loss of control. When the vehicle has slowed to such a speed that it is safe to do so, brake carefully and pull off the road. Drive off the road as far as possible and park on firm, level ground. If you are on a divided highway, do not park in the median area between the two traffic lanes.

2.When the vehicle is stopped, turn on your emergency hazard flashers, set the parking brake and put the transaxle in P (automatic transaxle) or reverse (manual transaxle).

3.Have all passengers get out of the vehicle. Be sure they all get out on the side of the vehicle that is away from traffic.

4.When changing a flat tire, follow the instruction provided later in this chapter.

If engine stalls while driving

1. Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place.

2. Turn on your emergency flashers.

3. Try to start the engine again. If your vehicle does not start, we recommend that you consult an authorized Kia dealer.

Road warning
Hazard warning flasher The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used w ...

If the engine will not start
If engine doesn't turn over or turns over slowly 1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check ...

Other information:

Kia Cee'd JD Owners Manual: Checking the tire inflation pressure
1. After driving approximately 7~10 km (4~6 miles or about 10 min), stop at a safety location. 2. Connect the filling hose (2) of the compressor directly to the tire valve. 3. Plug the compressor power cord into the vehicle power outlet. 4. Adjust the tire inflation pressure to the ...

Kia Cee'd JD Service Manual: Alternator Specifications
Specification Alternator [Non-ISG type]   Item Specification Rated voltage 13.5V, 90A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in typ ...

© 2017-2026 www.kceed.com