Kia Cee'd: Body Side Molding / Rear Spoiler Repair procedures
| • |
When prying with a flat-tip screwdriver, wrap it with protective
tape, and apply protective tape around the related parts, to
prevent damage.
|
| • |
Put on gloves to protect your hands.
|
|
| • |
Take care not to scratch the body surface.
|
|
| 1. |
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim")
|
| 2. |
Disconnect the high mounted stop lamp connector (A) and washer nozzle
(B).
|
| 3. |
Loosen the rear spoiler mounting nuts.
|
Tightening torque :
5.9 ~ 6.4 N.m (0.6 ~ 0.65 kgf.m, 4.3 ~ 4.7 lb-ft)
|
|
| 4. |
Remove the rear spoiler (A).
|
| 5. |
Install in the reverse order of removal.
| •
|
Make sure the connector is connected properly.
|
| •
|
Replace any damaged clips.
|
|
|
Replacement
[General Type]
•
When prying with a flat-tip screwdriver, wrap it wit ...
Replacement
•
When prying with a flat-tip screwdriver, wrap it with protective
...
Other information:
Kia Cee'd JD Owners Manual: Changing a tire with TPMS
If you have a flat tire, the low Tire
Pressure and Position telltales will
come on. We recommend that the
system be checked by an authorized
Kia dealer.
CAUTION
We recommend that you use the
sealant approved by Kia.
The sealant on the tire pressure
sensor and wheel shall be eleminated ...
Kia Cee'd JD Service Manual: Photo Sensor Repair procedures
Inspection
1.
Turn the ignition switch ON.
2.
Connect the GDS.
3.
Emit intensive light toward the photo sensor using a lamp, and check
the output voltage change.
4.
The ...
Roof Garnish Repair procedures
Front Wheel Guard Repair procedures