Kia Cee'd: Intake And Exhaust System / Air Cleaner Repair procedures

Removal and Installation
1.
Remove the engine cover.
2.
Disconnect the battery negative terminal.
3.
Remove the air duct and air cleaner assembly.
Tightening torque
Hose clamp bolt:
2.9 ~ 4.9N.m (0.3 ~ 0.5kgf.m, 2.2 ~ 3.6lb-ft)
Air cleaner assembly bolts:
3.9 ~ 5.9N.m (0.4 ~ 0.6kgf.m, 2.9 ~ 4.3lb-ft)
(1)
Remove the air duct(A).
(2)
Disconnect the breather hose (B) and air intake hose (C).
(3)
Remove the air cleaner assembly (D).

4.
Install in the reverse order of removal.
Air Cleaner Components and components location
Components   1. Air intake hose 2. Air cleaner cover 3. Air cleaner filter 4. Air cleaner body 5. Resonator 6. Air duct ...

Variable Intake Solenoid(VIS) Actuator Repair procedures
Removal and Installation 1. Disconnect the battery nagative terminal. 2. Disconnect the lever (A) and hose (B). 3. ...

Other information:

: cityseeker (If Equipped)
Note: cityseeker point of interest (POI) information is limited to approximately 1,110 cities (1,049 in the United States, 36 in Canada and 15 in Mexico). cityseeker, when available, is a service that provides more information about certain points of interest such as restaurants, hotels and a ...

: Manually Opening the Fuel Filler Door - Excluding: Hybrid Electric Vehicle (HEV)/Plug-In Hybrid Electric Vehicle (PHEV)
Your vehicle does not have a fuel tank filler cap. Left-hand side. To open the fuel filler door, press the center rear edge of the fuel filler door and then release. Right-hand side. To open the fuel filler door, press the center rear edge of the fuel filler door and then release. ...

© 2017-2026 www.kceed.com