Kia Cee'd: Lighting / Static bending light
While driving the corner, for your sight and safety, the static bending light turns on automatically. The system will operate automatically as follows:
- When vehicle speed is under 10km/h and steering wheel angle approximately 80 degrees.
- When vehicle speed is over 10km/h and steering wheel angle approximately 35 degrees.
- When the vehicle is at a standstill.
- When moving rearwards with one of the above conditions satisfied the lights will light up the opposite direction.
Headlight (Headlamp) welcome
function
When the headlight switch is in the ON or
AUTO position and all doors (and tailgate)
are closed and locked, if you press
the door unlock button on the transmitter
or smart key, the headlights ...
Lighting control
The light switch has a Headlight and a
Parking light position.
To operate the lights, turn the knob at the
end of the control lever to one of the following
positions:
(1) OFF position
(2) P ...
Other information:
Kia Cee'd JD Service Manual: Side Airbag (SAB) Module Repair procedures
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
1.
Disconnect the battery negative cable and wait ...
Kia Cee'd JD Service Manual: PTC Heater (Diesel Engine) Repair procedures
Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode and maximum heating position.
(2)
...
