The rear window wiper and washer switch is located at the end of the wiper and washer switch lever. Turn the switch to desired position to operate the rear wiper and washer.
- Normal wiper operation
--- - Intermittent wipe
O - Wiper is not in operation
Push the lever away from you to spray rear washer fluid and to run the rear wipers 1~3 cycles. The spray and wiper operation will continue until you release the lever.
Kia Cee'd JD Service Manual: Auto Defogging Sensor Repair procedures
Inspection
To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC
guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging sensor cover (A) by pulling i ...
Kia Cee'd JD Service Manual: Delivery Pipe Repair procedures
Removal
In case of removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, there may be injury caused by leakage
of the high pressure fuel. So don’t do any repair w ...