Kia Cee'd: Rear Suspension System / Rear Stabilizer Bar Repair procedures

Kia Cee'd JD Service Manual / Suspension System / Rear Suspension System / Rear Stabilizer Bar Repair procedures

Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Loosen the nut and then remove the rear stabilizer link (A) from the rear lower arm & stabilizer bar.
Tightening torque:
98.1 ~ 117.7N.m (10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

4.
Loosen the mounting bolt and then remove the stabilizer bar (A) from the sub frame.
Tightening torque:
44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

5.
Install in the reverse order of removal.
Inspection
1.
Check the rear stabilizer bar for deformation.
2.
Check the rear stabilizer link ball joint for damage.
Rear Lower Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Rear Assist Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specifications   Item Specification Power source DC 14.4V (-) ground Frequency range / Channel space FM : 87.5 ~ 108 MHz / 50 KHz AM : 522 ~ 1620 KHz / 9 KHz Tuning type ...

Kia Cee'd JD Service Manual: Repair procedures
Inspection Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multi-function switch. Lighting Switch (Auto Light) Lighting S ...

© 2017-2025 www.kceed.com