Kia Cee'd: Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Repair procedures

Replacement

•	When installing the belt, make sure not to damage the retractor.

1.	Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar Trim")

After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

After loosening the mounting bolt, then remove the rear seat belt retractor (A).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Rear Seat Belt Retractor Components and components location

Component Location 1. Rear seat belt retractor ...

Rear Center Seat Belt Retractor Components and components location

Component Location 1. Rear center seat belt retractor ...

Other information:

Kia Cee'd JD Owners Manual: If you do decide to pull a trailer
Here are some important points if you decide to pull a trailer: Consider using a sway control.You can ask a hitch dealer about sway control. Do not do any towing with your car during its first 2,000 km (1,200 miles) in order to allow the engine to properly break in. Failure to heed th ...

Kia Cee'd JD Owners Manual: Windshield defrosting and defogging
WARNING - Windshield heating Do not use the position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this ca ...