Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 2 Description and operation

The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).

It provides important input information for electric control.

The information is needed in all operations, including feedback control, gear shift control and failure detection of other sensors.

Input Speed Sensor 1 Repair procedures

Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the batte ...

Input Speed Sensor 2 Specifications

Specification Input Speed Sensor 2 ▷ Type: Hall effect sensor ▷ Specifications   Item Specifications Output voltage (V) ...

Other information:

Kia Cee'd JD Service Manual: Brake Booster Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when ...

: Mobile Communications Equipment
WARNING: Driving while distracted can result in loss of vehicle control, crash and injury. We strongly recommend that you use extreme caution when using any device that may take your focus off the road. Your primary responsibility is the safe operation of your vehicle. We recommend against th ...