Kia Cee'd: Dual Clutch Transmission Control System / Inhibitor Switch Description and operation

The inhibitor switch is mounted on the transmission case. It includes the electric switch plate circuit and is directly connected with the transmission lever via transmission cable.

When the driver shifts the transmission lever, the contact point on the switch plate varies and the electric current process changes, and engages the gear intended by the driver.

In addition, the inhibitor switch cuts off power from the circuit to prevent the motor from running if the driver attempts to start the engine from any gear positions other than P or N.

Input Speed Sensor 2 Repair procedures

Inspection Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor. Removal 1. Turn off the ignition switch and then disconnect the batte ...

Inhibitor Switch Specifications

Specification ▷ Type: Single signal output type ▷ Specifications   Item Specifications Output type Combined sign ...

Other information:

Kia Cee'd JD Service Manual: Rear Stabilizer Bar Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wheel and tire (A) from rear hub. Tightening torque: 88.2 ~ 1 ...

: MyKey Settings
Non-Configurable MyKey Settings Seatbelt Reminder or Belt-Minder™ MyKey mutes the audio system until the front seat passengers buckle the front seat belts. Note: If your vehicle includes an AM/FM radio or a very basic audio system, then the radio may not mute. Satellite Radio (If Equipped) Som ...