Kia Cee'd: Troubleshooting / In car sensor (DATC only) Description and operation

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / In car sensor (DATC only) Description and operation

Description
The In-car air temperature sensor is built in the heater & A/C control unit.
The sensor contains a thermistor which measures the temperature of the inside. The signal decided by the resistance value which changes in accordance with perceived inside temperature, is delivered to the heater control unit and according to this signal the control unit regulates the in-car temperature to the intended value.

Evaporator Temperature Sensor Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. ...

Photo Sensor Description and operation
Description The photo sensor is located at the center of the defrost nozzles. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation recei ...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting   Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel bearing Replace ...

Kia Cee'd JD Service Manual: Front Oil Seal Repair procedures
Removal and Installation 1. Crankshaft damper pulley. (Refer to Timing System - "Damper Pulley") 2. Remove the front oil seal.    ...

© 2017-2026 www.kceed.com