Kia Cee'd: Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Blind Spot Detection system / Blind Spot Detection Switch Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the lower crash pad switch assembly (A) after loosening screws.

Inspection

1.	Remove the lower crash pad switch assembly.

2.	Connect the battery voltage to terminals 3 and the ground to terminal 4.

Measure the voltage between terminals 4 and 2 at each position.

[Switch Position]

Position No.	Rotation	Voltage (V) (±5%)
0	0°	10.85
1	15°	9.78
2	30°	9.17
3	45°	8.55
4	60°	7.94
5	75°	7.32
6	90°	6.71

4.	If the voltage is not as specified, replace the head lamp leveling switch.

Blind Spot Detection Switch Components and components location

Circuit Diagram ...

Blind Spot Detection Indicator Components and components location

Components ...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specifications Front Suspension Item Specification Suspension type MacPherson Strut Shock absorber Type Gas Rear Suspension Item ...

Kia Cee'd JD Owners Manual: Anti-lock brake system (ABS) warning light
This light illuminates if the ignition switch is turned ON and goes off in approximately 3 seconds if the system is operating normally. If the ABS warning light remains on, comes on while driving, or does not come on when the ignition switch is turned to the ON position, this indicate ...