Kia Cee'd: Audio / Audio Unit Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Audio / Audio Unit Repair procedures

Removal
  
Take care not to scratch the center fascia panel and related parts.
Eject all the disc before removing the audio unit to prevent damaging the CD player's load mechanism.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).

3.
Disconnect the start/stop button connector (A).

4.
Loosen the mounting screws (4EA).
Remove the audio assembly (A) after disconnecting the connectors and cables (B).

  
If the CD does not eject, do not attempt to remove it because the audio unit may be damaged.Contact an authorized dealership for assistance.
Installation
1.
Connect the connectors and cables.
2.
Install the audio assembly.
3.
Install the center fascia panel.
4.
Connect the negative (-) battery terminal.
  
Make sure the audio head unit connectors are plugged in properly and the antenna cable is connected properly.
Audio Unit Components and components location
Components ...

Speakers Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying ...

Other information:

Kia Cee'd JD Owners Manual: Turn signal light
Follow the steps 1 to 7 from the previous page. 8. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 9. Remove the bulb from the socket by pressing it in and rotating it counterclockwise until ...

Kia Cee'd JD Owners Manual: Follow the steps 1 to 7 from the previous chapter.
8. Remove the cover by turning it counterclockwise. 9. Disconnect the headlight bulb socketconnector. 10. Unsnap the headlight bulb retaining wire by depressing the end and pushing it upward. 11. Remove the bulb from the headlight assembly. 12. Install a new headlight bulb and snap the h ...

© 2017-2026 www.kceed.com