Kia Cee'd: Charging System / Alternator Description and operation

Kia Cee'd JD Service Manual / Engine Electrical System / Charging System / Alternator Description and operation

Description
The Alternator has eight built-in diodes, each rectifying AC current to DC current.
Therefore, DC current appears at alternator "B" terminal.
In addition, the charging voltage of this alternator is regulated by the battery voltage detection system.
The alternator is regulated by the battery voltage detection system.
The main components of the alternator are the rotor, stator, rectifier, capacitor brushes, bearings and V-ribbed belt pulley.
The brush holder contains a built-in electronic voltage regulator.

 
1. Brush
2. Drive belt pulley
3. Rotor
4. Stator
5. Rectifier

Repair procedures
On-vehicle Inpection    • First of all, check for DTCs. If a DTC is present, perform tro ...

Alternator Specifications
Specification Alternator [Non-ISG type]   Item Specification Rated voltage 13.5V, 90A Speed in use ...

Other information:

Kia Cee'd JD Service Manual: TPMS Receiver Schematic diagrams
Circuit Diagram Hamess Connector   Pin No. Discription 1 Battery ECU 2 Ignition ON 3 CAN_HIGH 4 CAN_LOW ...

Kia Cee'd JD Owners Manual: Static bending light
While driving the corner, for your sight and safety, the static bending light turns on automatically. The system will operate automatically as follows: When vehicle speed is under 10km/h and steering wheel angle approximately 80 degrees. When vehicle speed is over 10km/h and ste ...

© 2017-2025 www.kceed.com