Kia Cee'd: Dual Clutch Transmission Control System / Gear Actuator Motor Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Gear Actuator Motor Repair procedures

Inspection

1.	Turn off the ignition switch.

2.	Disconnect the shift actuator connector (A) and select actuator connector (B).

3.	Measure the resistance on the gear actuator motor terminal.

4.	Refer to the specifications and check that the measured resistance is as specified. (Refer to Gear Actuator Motor - "Specification")

Removal

1.	Remove the gear actuator assembly. (Refer to Dual Clutch Transmission Control System - "Gear actuator")

Gear Actuator Motor Schematic diagrams

Schematic Diagrams ...

Input Speed Sensor 1 Description and operation

Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM). It provides i ...

Other information:

: Rear Parking Aid
(If Equipped) What is the Rear Parking Aid Rear parking sensors detect objects behind your vehicle when in reverse (R). Rear Parking Aid Limitations There is a decreased coverage area at the outer corners. When using a programmed MyKey, you cannot switch the rear parking aid off. The rear parking ...

Kia Cee'd JD Service Manual: Repair procedures
Removal 1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the lower anchor bolt. 3. Remove the center pillar trim. (Refer to Body - &q ...