Kia Cee'd: Manual Transaxle System / Troubleshooting
Kia Cee'd JD Service Manual / Manual Transaxle System / Troubleshooting
| Troubleshooting |
|
Trouble symptom |
Suspect area |
Remedy |
|
Abnormal noise |
Oil level (Low) |
To adding oil after inspect the parts. (oil seal, drain plug, filler plug)
|
|
Oil (Wrong or contaminated) |
Replace the oil. |
|
|
Transaxle and engine mounting state (Wrong) |
Tighten the mounting bolt with specified torque. |
|
|
Shaft end play (Wrong) |
Adjust the end play. |
|
|
Synchronizer ring (Worn or damaged) |
Replace the synchronizer ring. |
|
|
Gear (Worn or damaged) |
Replace the gear. |
|
|
Bearing (Worn or damaged) |
Replace the bearing. |
|
|
Oil leak |
Oil level (High) |
Inspect the oil level. |
|
Gasket (Damaged) |
Replace the gasket. (drain plug, filler plug) |
|
|
Oil seal (Worn or damaged) |
Replace the oil seal. |
|
|
Hard shifting or impossible to shift |
Oil (Wrong) |
Replace the oil. |
|
Shift fork (Worn) |
Replace the shift fork. |
|
|
Synchronizer ring (Worn or damaged) |
Replace the synchronizer ring. |
|
|
Gear (Worn or damaged) |
Replace the gear. |
|
|
Hub sleeve (Worn or damaged) |
Replace the hub sleeve. |
|
|
Jumps out of gear |
Shift fork (Worn) |
Replace the shift fork. |
|
Hub sleeve (Worn or damaged) |
Replace the hub sleeve. |
|
|
Gear (Worn or damaged) |
Replace the gear. |
|
|
Bearing (Worn or damaged) |
Replace the bearing. |
Special service tools
Special Service Tools
Tool Name / Number
Illustration
Description
Engine support fixture (bar)
09200-3N000
...
Other information:
Kia Cee'd JD Service Manual: ISG (Idle Stop & Go) Components and components location
Components Location
1 . Battery sensor
2 . Brake Booster Vacuum Pressure Sensor (BBVPS)
3 . AGM battery
4 . DC DC converter
5 . ISG OFF switch
6. Alternator
7 . Starter
8. Neutral switch
9. Clutch switch
10. Door switch
11 ...
Kia Cee'd JD Service Manual: Description and operation
Warning Lamp Activation
Warning Lamp Behavior after Ignition
On
As soon as the operating voltage is applied to the SRSCM ignition input, the
SRSCM activates the warning lamp for a LED lamp check.
The lamp shall turn on for 6 seconds during the initialization ...
© 2017-2025 www.kceed.com
