Kia Cee'd: Rear Suspension System / Rear Assist Arm Repair procedures

Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

  
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).
3.
Remove the rear shock absorber.
(Refer to Rear Suspension System - "Rear Shock Absorber")
4.
Remove the sprit pin and castle nut and then disconnect the rear assist arm (A) from the rear axle.
Tightening torque:
44.1 ~ 54.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

5.
Using the SST (09568-4A000), disconnect the assist arm (A) from the carrier assembly.

6.
Loosen the bolt & nut and then remove the rear assist arm (A) from the sub frame.
Tightening torque:
107.9 ~ 117.7 N.m (11.0 ~ 12.0 kgf.m, 79.6 ~ 86.8 lb-ft)

7.
Install in the reverse order of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check for all bolts and nut.
Rear Stabilizer Bar Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Trailing Arm Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specifications Fuel Delivery System   Items Specification Fuel Tank Capacity 53 lit. (14.0 U.S.gal., 56.0 U.S.qt., 46.6 Imp.qt.) Fuel Filter Type Paper type ...

Kia Cee'd JD Service Manual: Accelerator Position Sensor (APS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specificati ...

© 2017-2026 www.kceed.com