Kia Cee'd: Rear Suspension System / Trailing Arm Repair procedures

Kia Cee'd JD Service Manual / Suspension System / Rear Suspension System / Trailing Arm Repair procedures

Replacement

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the rear wheel and tire (A) from rear hub.

Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

•	Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

3.	Disconnent the parking brake cable. (Refer to Brake System - "Rear Disc Brake")

Loosen the bolt (B,C) & nut (D) and then remove the rear trailing arm (A) from the rear axle.

Tightening torque:

(B) 98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

(D) 44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)

5.	Install in the reverse order of removal.

Rear Assist Arm Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Rear Cross Member Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear wh ...

Other information:

: Second Stage: Checking the tire pressure with the inflator kit
WARNING: If the tire does not inflate to the recommended tire pressure within 15 minutes, stop and call roadside assistance. WARNING: The power plug may get hot after use and should be handled carefully when unplugging. Check the air pressure of your tires as follows: Remove the valve cap f ...

Kia Cee'd JD Owners Manual: Pairing through [PHONE] Setup
Press the key Select [Phone] Select [Pair Phone] The following steps are the same as those described in the section "When No Devices have been Paired" on the previous page. ✽ NOTICE The waiting period during phone pairing will last for one minute. The pairing process will fai ...