Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 1 Description and operation

The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).

It provides important input information for electric control.

The information is needed in all operations, including feedback control, gear shift control and failure detection of other sensors.

Gear Actuator Motor Repair procedures

Inspection 1. Turn off the ignition switch. 2. Disconnect the shift actuator connector (A) and select actuator connector (B). ...

Input Speed Sensor 1 Specifications

Specification Input Speed Sensor 1 ▷ Type: Hall effect sensor ▷ Specifications   Item Specifications Output voltage (V) ...

Other information:

Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be removed as follows: 1. Turn off the engine. 2. Disconnect the negative battery cable. 3. Remove the fuse panel on the right side in the engine compartment. 4. Remove the nuts shown in the picture above. 5. Replace the fuse with a new one of the s ...

Kia Cee'd JD Service Manual: Front Stabilizer Link Repair procedures
Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.2 ...