Kia Cee'd: What to do in an emergency / If the engine will not start

Kia Cee'd JD Owners Manual / What to do in an emergency / If the engine will not start

If engine doesn't turn over or turns over slowly

1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2. Check the battery connections to be sure they are clean and tight.

3. Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4. Check the starter connections to be sure they are securely tightened.

5. Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING

If the engine does not start, do not push or pull the vehicle to start it. This could result in a collision or cause other damage. In addition, push or pull starting may cause the catalytic converter (if equipped) to be overloaded and create a fire hazard.

If engine turns over normally but does not start

1. Check fuel level.

2. With the ignition switch in the LOCK/ OFF position, check all connectors at ignition, coil and spark plugs. Reconnect any that may be disconnected or loose.

3. Check the fuel line in the engine compartment.

4. If the engine still does not start, we recommend that you call an authorized Kia dealer.

In case of an emergency while driving
If the engine stalls at a crossroad or crossing If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe plac ...

Emergency starting
■ Engine compartment Connect cables in numerical order and disconnect in reverse order. ...

Other information:

: Closing the Liftgate
Closing the Liftgate From Inside Your Vehicle WARNING: Make sure all persons are clear of the power liftgate area before using the power liftgate control. With the transmission in park (P), press the button on the instrument panel. Note: Make sure that you close the liftgate before operating o ...

Kia Cee'd JD Service Manual: Speakers Repair procedures
Inspection 1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the speaker mounting screws are removed and the wiring connector is connected to ...

© 2017-2026 www.kceed.com