Kia Cee'd: IMS (Integrated Memory) / IMS Power Seat Control Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / IMS (Integrated Memory) / IMS Power Seat Control Repair procedures

Inspection

1.	Disconnect the IMS control switch connector.

2.	With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch.

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front door trim panel. (Refer to Body - "Front Door Trim")

3.	After removing the mounting screws and switch connector (B), then remove the IMS control switch bracket (A) from the front door trim panel.

Installation

–	Make sure that the IMS control switch connectors and related connectors are plugged in properly.

–	Check the IMS control switch operates normally.

1.	Connect the connectors and reassemble the IMS control switch.

2.	Reassemble the seat side cover.

IMS Power Seat Control Schematic diagrams

Circuit diagram ...

IMS Control Switch Schematic diagrams

Circuit diagram ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Components 1. Slide motor 2. Front height motor 3. Rear height motor 4. Power seat cotrol switch 5. Recline motor 6. Recline control switch 7. Lumbar support motor 8. Lumbar support switch ...

Kia Cee'd JD Owners Manual: Engine compartment panel fuse replacement
Diesel only 1. Turn the ignition switch and all other switches off. 2. Remove the fuse box cover by pressing the tap and pulling up. When the blade type fuse is disconnected, remove it by using the clip designed for changing fuses located in the engine room fuse box. Upon removal, ...