Kia Cee'd: Special driving conditions / Highway driving
Tires
Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires.
Avoid using worn or damaged tires which may result in reduced traction or tire failure.
✽ NOTICE
Never exceed the maximum tire inflation pressure shown on the tires.
WARNING
- Underinflated or overinflated tires can cause poor handling, loss of vehicle control, and sudden tire failure leading to accidents, injuries, and even death. Always check the tires for proper inflation before driving. For proper tire pressures, refer to chapter 8, “Tires and wheels”.
- Driving on tires with no or insufficient tread is dangerous. Wornout tires can result in loss of vehicle control, collisions, injury, and even death. Worn-out tires should be replaced as soon as possible and should never be used for driving. Always check the tire tread before driving your vehicle. For further information and tread limits, refer to chapter 7, “Tires and wheels”.
Fuel, engine coolant and engine oil
High speed travel consumes more fuel than urban motoring. Do not forget to check both engine coolant and engine oil.
Drive belt
A loose or damaged drive belt may result in overheating of the engine.
Driving off-road
Drive carefully off-road because your
vehicle may be damaged by rocks or
roots of trees. Become familiar with the
off-road conditions where you are going
to drive before you begin driving. ...
Winter driving
Severe weather conditions in the winter
result in greater wear and other problems.
To minimize the problems of winter
driving, you should follow these suggestions: ...
Other information:
Kia Cee'd JD Service Manual: Camshaft Components and components location
Components
1. Exhaust camshaft
2. Intake camshaft
3. Camshaft bearing cap
4. Camshaft front bearing cap
5. OCV (Oil Control Valve) adapter
6. O-ring B
7. O-ring A
...
Kia Cee'd JD Service Manual: Rear Door Outside Handle Repair procedures
Replacement
[Rear Door Outside Handle]
1.
Remove the hole plug (B).
2.
After loosening the mounting bolt, then remove the rear door outside
handle cover (A).
Tightening torque :
...
