Kia Cee'd: Button Engine Start System / ESCL(Electronic Steering Column Lock) Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Button Engine Start System / ESCL(Electronic Steering Column Lock) Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remoove the driver crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel")

3.	Remove the steering column shroud upper and lower panel. (Refer to Body - "Steering Column Shroud Panel")

4.	Disconnect the electronic steering column lock connector (A).

5.	Remove the electronic steering column lock after loosening shear bolts. (Refer to Steering System - "Steering Column and Shaft")

Installation

Install the electronic steering column lock (A).

Do not reuse the shear bolts.

When installing the new shear bolts to the electronic steering column lock, tighten the shear bolts until its head is cut off.

Tightening torque :

7 ~ 13 N.m (0.7 ~ 1.3 kgf.m, 5 ~ 9.4 lb.ft)

2.	Install the steering column.

3.	Install the crash pad lower panel and shroud panel.

ESCL(Electronic Steering Column Lock) Components and components location

Component ...

Ignition Switch Assembly

...

Other information:

Kia Cee'd JD Service Manual: Panoramaroof Motor Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") 3. Disconnect the connector (A). 4 ...

Kia Cee'd JD Owners Manual: To turn off the speed limit control, do one of the following
Move the lever up (). Move the lever down (). (If you move the lever down, the cruise system will turn on) Turn the ignition off. If you press the O (CANCEL) button once, the set speed limit will cancel, but it will not turn the system off. If you wish to reset the speed l ...