Ford Escape: Keyless Entry / Keyless Entry Settings

Switching Keyless Entry On and Off

  1. Switch the ignition on using an original key that has not been created as a MyKey.
  2. Press Settings on the touchscreen.
  3. Press Vehicle Settings.
  4. Press Locks.

Reprogramming the Unlocking Function

You can enable two-stage unlocking function allowing you to unlock only the driver door when you touch the unlock sensor.

Press and hold both the lock and unlock buttons on the remote control for four seconds to disable or enable two-stage unlocking.

If you program the unlocking function so that only the driver door unlocks, you can unlock all of the other doors from inside your vehicle using the power door lock control. You can unlock individual doors by pulling the interior door handles on those doors.

Creating Personal Access Codes

To create your own personal access code:

  1. Enter the factory-set code.
  2. Press 1·2 on the keypad within five seconds.
  3. Enter your personal five-digit code.
  4. Press 1·2 on the keypad to save personal code one.

The doors lock then unlock to confirm that programming was successful.

To program additional personal access codes, repeat Steps 1-3, then for Step 4:

Hints:

Clearing All Personal Access Codes

  1. Enter the factory-set five-digit code.
  2. Press and release 1·2 on the keypad within five seconds.
  3. Press and hold 1·2 for a few seconds. This must be done within five seconds of completing Step 2.

All personal codes erase and only the factory-set five-digit code works.

Master Access Code
What Is the Master Access Code The master access code is a factory-set five-digit entry code. You can operate the keypad with the master access code at any time. The master access code is on the o ...

Locking and Unlocking the Doors Using Keyless Entry
Unlocking the Doors - Vehicles With: Keyless Entry and Push Button Start With your intelligent access key within 3 ft (1 m) of your vehicle, touch the unlock sensor on the back of the door handle f ...

Other information:

Ford Escape 2020-2021 Owners Manual: Under Hood Overview - 2.5L, Hybrid Electric Vehicle (HEV)/Plug-In Hybrid Electric Vehicle (PHEV)
Windshield washer fluid reservoir: See Adding Washer Fluid. Low temp coolant cap: See Checking the Coolant. High temp coolant cap: See Checking the Coolant. Engine oil filler cap: See Adding Engine Oil. Engine oil dipstick: See Engine Oil Dipstick Overview. Brake fluid reservoir: See Checkin ...

Kia Cee'd JD Service Manual: Heater Core Repair procedures
Replacement 1. Disconnect the negative (-) battery terminal. 2. Remove the heater & blower assembly. (Refer to Heater - "Heater Unit") 3. Remove the heater core cover (A) after loos ...

© 2017-2021 www.kceed.com