Kia Cee'd: Engine Room Under Cover / Engine Mounting Repair procedures

Kia Cee'd JD Service Manual / Engine Mechanical System / Engine Room Under Cover / Engine Mounting Repair procedures

Removal and Installation

[Rollroad mounting]

Rollroad bracket mounting bolts and rollroad bracket (A).

Tightening torque

Nut (B) :

107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)

Bolt (C) :

49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Remove the Rollroad supprt bracket(A).

Tightening torque:

49.0 ~ 68.6 N.m (5.0 ~ 7.0 kgf.m, 36.2 ~ 50.6 lb-ft)

3.	Install in the reverse order of removal.

[Engine mounting support bracket]

Install the jack to the edge of upper oil pan to support the engine.

Insert the rubber block between jack and oil pan.

Disconnect the ground cable(A), and remove the engine mounting support bracket(B).

Tightening torque

Ground line bolt :

10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)

Nut (C) :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Bolt (D) and nuts (E) :

58.8 ~ 73.5 N.m (6.0 ~ 7.5 kgf.m, 43.3 ~ 54.2 lb-ft)

3.	Install in the reverse order of removal.

[Transaxle mounting bracket]

1.	Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery")

2.	Remove the under cover.

3.	Install the jack to the edge of transaxle.

4.	Remove the cover (A).

Remove the transaxle support bracket mounting bolt (A).

Tightening torque :

88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

Remove the transaxle mounting bracket (A).

Tightening torque :

63.7 ~ 83.3 N.m (6.5 ~ 8.5 kgf.m, 47.0 ~ 61.5 lb-ft)

Manual Transaxle

Auto Transaxle

7.	Install in the reverse order of removal.

Engine Mounting Components and components location

Components 1. Transaxle mounting bracket 2. Roll road bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

Engine And Transmission Assembly Repair procedures

Removal • Use fender covers to avoid damaging painted surfaces. ...

Other information:

Kia Cee'd JD Service Manual: Radiator Repair procedures
Removal and Installation 1. Disconnect the battery negative terminal. 2. Remove the air cleaner assembly. (Refer to Intake and exhaust system - "Air Cleaner") 3. Remove the battery tray. ...

: Creating a MyKey - Vehicles With: Push Button Start. Creating a MyKey - Vehicles With: Flip Key
Creating a MyKey - Vehicles With: Push Button Start Remove the mat covering the backup location. Remove the key blade from the transmitter. Place the passive key in the position shown, with the buttons facing upward. Switch the ignition on. Using your touchscreen, press Menu. Press Set ...