Kia Cee'd: Troubleshooting / Cluster Ionizer Description and operation

The cluster ionizer makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle.

When running an air-conditioner or heater, it starts with "CLEAN" mode and repeats from "CLEAN" mode to "ION" mode and from "ION" mode to "CLEAN" mode every 15 minutes.

In the “CLEAN” mode, the cluster ionizer generates negative ions and positive ions and makes disinfection and decomposition of bad smell from the air-conditioner or inflow air.

It has an operation indicator lamp on the display area and shows whether it is operating or not.

In the “ION” mode, the cluster ionizer generates negative ions and cleans the inside air of a vehicle. It has an operation indicator lamp on the display area and shows whether it is operating or not.

Auto Defogging Sensor Repair procedures

Inspection To inspect and diagnose the sensor, refer to Self-Diagnosis procedure and DTC guide. Replacement 1. Disconnect the negative (-) battery ...

Cluster Ionizer Repair procedures

Inspection 1. Press the VENT switch more then 4 times within 2 seconds while pressing the OFF switch.   Display F ...

Other information:

Kia Cee'd JD Service Manual: Rear Bumper beam Assembly Components and components location
Component Location   1. Rear bumper beam assembly ...

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Description and operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop because of CKPS signal missing. This sensor is installed in ladder fra ...