Kia Cee'd: Troubleshooting / Cluster Ionizer Repair procedures

Inspection
1.
Press the VENT switch more then 4 times within 2 seconds while pressing the OFF switch.
 
Display
Fail description
00
Normal
50
Cluster ion generator fault

* For diagnostic procedure, refer to DTC guide.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
3.
Remove the shower duct (A).

4.
Disconnect the connector and then remove the cluster ionizer (B) after loosening the mounting screws.

5.
Install in the reverse order of removal.
Cluster Ionizer Description and operation
Description The cluster ionizer makes disinfection and decomposition of bad smell from the air-conditioner or inflow air. And it cleans the inside air of a vehicle. When runni ...

Heater
...

Other information:

Kia Cee'd JD Service Manual: Inside Rear View Mirror Repair procedures
Replacement [Manual Mirror] 1. Loosen the inside rear view mirror mounting screw (C). 2. Push the inside rear view mirror base (B) up to remove the inside rear view mirror assembly (A). 3. ...

Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform [NON-ISG] This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using these signals. Generally CkPS signal is used to dete ...

© 2017-2026 www.kceed.com