Kia Cee'd: Blower / Blower Resistor (Manual) Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Blower / Blower Resistor (Manual) Repair procedures

Inspection
1.
Measure the resistance between the terminals.
2.
If the measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor.)

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the connector (A) and then remove the blower resistor (B) after loosening the mounting screws.

3.
Install in the reverse order of removal.
Blower Motor Repair procedures
Inspection 1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, ...

Power Mosfet (DATC) Repair procedures
Inspection 1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. ...

Other information:

Kia Cee'd JD Service Manual: Transmission Control Module (TCM) Description and operation
Description The Transmission Control Module (TCM) is like the brain for the Dual Clutch Transmission (DCT). It receives information from various sensors for a wide range of transmission controls to provide an optimal driving environment for the driver. The TCM is programmed ...

Kia Cee'd JD Owners Manual: Windshield defrosting and defogging
WARNING - Windshield heating Do not use the position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this ca ...

© 2017-2026 www.kceed.com