Kia Cee'd: Features of your vehicle / Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the 
position
during
cooling operation in extremely
humid weather. The difference
between the temperature of the outside
air and the windshield could
cause the outer surface of the
windshield to fog up, causing loss
of visibility. In this case, set the
mode selection to the 
position
and fan speed control to the lower
speed.
- For maximum defrosting, set the temperature control to the hottest position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grill to improve heater and defroster efficiency and to reduce the probability of fogging up the inside of the windshield.
Checking the amount of air conditioner
refrigerant and compressor
lubricant
When the amount of refrigerant is low,
the performance of the air conditioning is
reduced. Overfilling also has a bad influence
on the air conditioning system.
Therefore, if abnormal operation ...
Other information:
Kia Cee'd JD Owners Manual: Closing the hood
1. Before closing the hood, check the following:
All filler caps in engine compartment
must be correctly installed.
Gloves, rags or any other combustible
material must be removed
from the engine compartment.
2. Return the support rod to its clip to
prevent it from rattling.
3. L ...
Kia Cee'd JD Owners Manual: Auto light/AFLS position
When the light switch is in the AUTO light
position, the taillights and headlights will
be turned ON or OFF automatically
depending on the amount of light outside
the vehicle.
If your vehicle is equipped with the adaptive
front lighting system (AFLS), it will
also operate when the hea ...
