Operates as follows when the ignition switch is turned ON.
: For a single wiping cycle, move
the
lever to this position and release it.
The wipers will operate continuously if
the lever is held in this position.
O : Wiper is not in operation
--- :Wiper operates intermittently at the same wiping intervals. Use this mode in light rain or mist.To vary the speed setting, turn the speed control knob.
1 : Normal wiper speed
2 : Fast wiper speed
✽ NOTICE
If there is heavy accumulation of snow or ice on the windshield, defrost the windshield for about 10 minutes, or until the snow and/or ice is removed before using the windshield wipers to ensure proper operation. If you do not remove the snow and/or ice before using the wiper and wash-er, it may damage the Wiper and washer system.
Wipers and washers
AUTO (Automatic) controlKia Cee'd JD Service Manual: BJ Boot Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Rem ...
: Switching Driver Alert On and Off. Driver Alert Indicators
Switching Driver Alert On and Off
Press Settings on the touchscreen.
Press Driver Assistance.
Switch Driver Alert on or off.
Note: The system remains on or off
depending on how it was last set.
Resetting Driver Alert
You can reset the system by either:
Switching the ignition off and on.
Sto ...