Kia Cee'd: Armed stage / Using the smart key
Park the vehicle and stop the engine. Arm the system as described below.
1. Turn off the engine.
2. Make sure that all doors, the engine hood and tailgate are closed and latched.
3. • Lock the doors by pressing the button of the front outside door handle with the smart key in your possession. After completion of the steps above, the hazard warning lights will operate once to indicate that the system is armed.
If the tailgate or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After this, if the tailgate and engine hood are closed, the hazard warning lights will blink once and the theft-alarm will arm.
• Lock the doors by pressing the lock button on the smart key.
After completion of the steps above, the hazard warning lights will operate once to indicate that the system is armed.
If the tailgate or engine hood remains opened, the hazard warning lights will not operate and theft-alarm will not arm. After this, if the tailgate and engine hood are closed, the hazard warning lights will blink once and the theft-alarm will arm.
Armed stage
...
Using the transmitter
Park the vehicle and stop the engine.
Arm the system as described below.
1.Turn off the engine and remove the
ignition key from the ignition switch.
2.Make sure that all doors, the engine
hood ...
Other information:
Kia Cee'd JD Owners Manual: Electronic Stability Control
(ESC) indicator
The ESC indicator will illuminate when
the ignition switch is turned ON, but
should go off after approximately 3 seconds.
When the ESC is on, it monitors
the driving conditions. Under normal driving
conditions, the ESC indicator will
remain off. When a slippery or low traction
condit ...
: Switching Pre-Collision Assist On and Off
You cannot switch the system off.
Adjusting the Pre-Collision Assist Settings
You can adjust the following settings by
using the touchscreen controls in the
pre-collision assist menu:
Change alert and distance alert
sensitivity to one of three possible
settings.
Switch distance indication a ...
