Kia Cee'd: Engine start/stop button position / START/RUN

With manual transaxle

To start the engine, depress the clutch pedal and brake pedal, then press the engine start/stop button with the shift lever in the N (Neutral) position.

With automatic transaxle/DCT

To start the engine, depress the brake pedal and press the engine start/stop button with the shift lever in the P (Park) or the N (Neutral) position. For your safety, start the engine with the shift lever in the P (Park) position.

✽ NOTICE

If you press the engine start/stop button without depressing the clutch pedal for manual transaxle vehicles or without depressing the brake pedal for automatic transaxle vehicles, the engine will not start and the engine start/stop button changes as follow:

OFF ➔ACC ➔ ON ➔ OFF or ACC

✽ NOTICE

If you leave the engine start/stop button in the ACC or ON position for a long time, the battery will discharge.

WARNING

ON
With manual transaxle Press the engine start/stop button when the button is in the ACC position without depressing the clutch pedal. With automatic transaxle/DCT Press the engine start/stop b ...

Starting the engine
WARNING Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots,etc.) may interfere with your ability to use the brake and accelerator ped ...

Other information:

Kia Cee'd JD Owners Manual: Jack and tools
The jack, jack handle, wheel lug nut wrench are stored in the luggage compartment. Pull up the luggage box cover to reach this equipment. (1) Jack handle (2) Jack (3) Wheel lug nut wrench Jacking instructions The jack is provided for emergency tire changing only. To prevent the jack ...

Kia Cee'd JD Service Manual: PTC Heater (Gasoline Engine) Repair procedures
Inspection Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the Floor mode and maximum heating position. (2) ...

© 2017-2025 www.kceed.com