Removal |
1. |
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
|
2. |
Pull out the SPAS sensor (A) by opening the sensor holder out.
|
3. |
Disconnect the connector form the sensor.
|
1. |
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
|
2. |
Pull out the SPAS sensor (A) by opening the sensor holder out.
|
3. |
Disconnect the connector form the sensor.
|
Installation |
1. |
Install the SPAS sensor and connector.
|
2. |
Install the front/rear bumper.
|
1. |
Install the SPAS sensor and connector.
|
2. |
Install the front bumper.
|
Kia Cee'd JD Service Manual: Temperature Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the warm position
when connecting 12V ...
Kia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Description and operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one
of the most important sensors of the engine control system. If there is no CKPS
signal input, the engine may stop because of CKPS signal missing.
This sensor is installed in ladder fra ...