Kia Cee'd: Troubleshooting / Refrigerant line Repair procedures

Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
  
Cap the open fittings immediately to keep moisture or dirt out of the system.
3.
Tighten joint of bolt or nut to specified torque.
  
Connections should not be torque tighter than the specified torque.
4.
Evacuate air in the refrigeration system and charge system with refrigerant.
Specified amount : 500 ± 25 g (17.6 ± 0.88 oz.)
5.
Inspect for leakage of refrigerant.
Using a gas leak detector, check for leakage of refrigerant.
6.
Inspect A/C operation.
Compressor Oil Repair procedures
Oil Specification 1. The R-134a or R-1234yf system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils ...

Compressor Description and operation
Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pr ...

Other information:

Kia Cee'd JD Owners Manual: Speed limiter indicator
The indicator illuminates when the speed limit control system is enabled by move the lever up on the steering wheel. The indicator goes off when the lever up again to deactivate the system. If there is a problem with the speed limit control system, the “---” indicator will blink. ...

Kia Cee'd JD Service Manual: Rear Wiper Motor Repair procedures
Inspection Rear Wiper Motor 1. Remove the 4P connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 3 and 4 respectively. 3. Check that the motor ...

© 2017-2026 www.kceed.com