Kia Cee'd: Driveshaft and axle / Rear Axle Assembly / Rear Hub - Carrier

BJ Boot Repair procedures

Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint asse ...

Components and components location

Components   1. Carrier assembly 2. Rear brake assembly 3. Hub & bearing assembly 4. Rear brake disc ...

Other information:

Kia Cee'd JD Service Manual: ETC (Electronic Throttle Control) System Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refe ...

Kia Cee'd JD Service Manual: Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symptom is detected, perform necessary remedy and inspection. &nb ...