Kia Cee'd: SRSCM / PAB ON/OFF Switch Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / PAB ON/OFF Switch Repair procedures

Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the crash pad side cover. (Refer to Body - "Crash pad side cover")

4.	Disconnect the PAB ON/OFF switch connector (A).

5.	Remove the PAB ON/OFF switch.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Install the PAB ON/OFF switch to the crash pad side cover.

4.	Connect the PAB ON/OFF switch connector.

5.	Install the crash pad side cover. (Refer to Body - "Crash pad side cover")

After installing the SRSCM, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

PAB ON/OFF Switch Components and components location

Components ...

Airbag Module

...

Other information:

Kia Cee'd JD Owners Manual: Answering Calls
Answering a Call Answering a call with a Bluetooth® Wireless Technology device connected will display the following screen. (1) Caller : Displays the other party’s name when the incoming caller is saved within your phone book (2) Incoming Number : Displays the incoming number (3) ...

: Airbag Precautions. Properly Adjusting the Driver and Front Passenger Seats
Airbag Precautions WARNING: Airbags do not inflate slowly or gently, and the risk of injury from a deploying airbag is the greatest close to the trim covering the airbag module. WARNING: All occupants of your vehicle, including the driver, should always properly wear their seatbelts, even whe ...