To activate an one-touch lane change function, move the turn signal lever slightly and then release it. The lane change signals will blink 3 times.
You can inactivate one-touch lane change function in “Auto triple turn” of “User setting”. Refer to “User setting” in chapter 4.
✽ NOTICE
If an indicator flash is abnormally quick or slow, bulb may be burned out or have a poor electrical connection in the circuit.
Turn signals and lane change signals
Front fog lightKia Cee'd JD Service Manual: Crankshaft Position Sensor (CKPS) Troubleshooting
Signal Waveform
[NON-ISG]
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position
Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing
by using these signals.
Generally CkPS signal is used to dete ...
Kia Cee'd JD Service Manual: Flex Steering Repair procedures
Inspection
1.
Check the audio remote control switch (A) for resistance between terminals
in each switch position.
Switch
Connector terminal
Resistance (±5%)
...