Kia Cee'd: Scheduled maintenance service / MAINTENANCE UNDER SEVERE USAGE CONDITIONS - EXCEPT EUROPE

Kia Cee'd JD Owners Manual / Maintenance / Scheduled maintenance service / MAINTENANCE UNDER SEVERE USAGE CONDITIONS - EXCEPT EUROPE

The following items must be serviced more frequently on cars mainly used under severe driving conditions. Refer to the chart below for the appropriate maintenance intervals.

R : Replace

I : Inspect and if necessary, adjust, correct, clean or replace

SEVERE DRIVING CONDITIONS

A : Repeated short distance driving
B : Extensive idling
C : Driving in dusty, rough roads
D : Driving in areas using salt or other corrosive materials or in very cold weather
E : Driving in heavy dust condition
F : Driving in heavy traffic area.
G : Driving in mountainous areas.
H : Towing a trailer or using a camper on roof rack
I : Driving for patrol car, taxi, commercial car or vehicle towing
J : Driving over 170 km/h (106 mile/h)
K : Frequently driving in stop-and-go conditions
L : Driving in very cold weather

NORMAL MAINTENANCE SCHEDULE - EXCEPT EUROPE

The following maintenance services must be performed to ensure good emission control and performance. Keep receipts for all vehicle emission services to protect your warranty. Where both mileage a ...

Explanation of scheduled maintenance items

Engine oil and filter The engine oil and filter should be changed at the intervals specified in the maintenance schedule. If the car is being driven in severe conditions, more frequent oil an ...

Other information:

Kia Cee'd JD Owners Manual: Tailgate unlocking
■ 3 Door and 5 Door ■ Wagon 1.Carry the smart key. 2. Press the tailgate handle switch. 3. The tailgate will unlock. ✽ NOTICE Once the tailgate is opened and then closed, the tailgate will lock automatically. The button will only operate when the smart key is within 0.7 m ...

Kia Cee'd JD Owners Manual: Headlight (Low, Non-HID Type)
Follow the steps 1 to 7 from the previous page. 8. Remove the cover by turning it counterclockwise. 9. Remove the socket from the assembly by turning the socket counterclockwise until the tabs on the socket align with the slots on the assembly. 10. Pull the bulb out of the socket. 11. ...