Removal |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - " Crash Pad Lower Panel")
|
3. |
Disconnect the connector of the immobilizer unit and then remove the
immobilizer unit (A) after loosening a nut and a bolt.
|
Installation |
1. |
Install the immobilizer control unit after connecting the unit connector.
|
2. |
Install the crash pad lower panel.
|
Kia Cee'd JD Service Manual: Repair procedures
Inspection
1.
After disconnecting the vapor hose from the PCV valve, remove the PCV
valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Run the engine at idle, then put a finger over the open end ...
Kia Cee'd JD Service Manual: Rear Wiper Motor Repair procedures
Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 3
and 4 respectively.
3.
Check that the motor ...