| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column shroud panel.
(Refer to Body - "Crash Pad Lower Panel")
|
| 3. |
Disconnect the connector (B) of the coil antenna and then remove the
coil antenna (A) after loosening the screw.
|
| Installation |
| 1. |
Install the coil antenna and connect the connector.
|
| 2. |
Install the steering column shroud panel.
|
Immobilizer Control Unit Repair proceduresKia Cee'd JD Service Manual: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Specification: Refer to "Specification"
...
: Programming a MyKey. Clearing All MyKeys. Checking MyKey System Status.
Using MyKey With Remote Start Systems
Programming a MyKey
You can program any remote control to
become a restricted MyKey, but you must
leave one unmodified as an admin key.
Switch the ignition on using an admin
key.
Press Settings on the touchscreen.
Press Vehicle Settings.
Press MyKey.
Select a setting and press the OK
but ...