Kia Cee'd: Hood / Hood Latch Repair procedures

Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Remove the hood latch (A) mounting bolts.
Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Disconnect the hood latch cable (A) and remove the hood latch (B).

4.
Install in the reverse order of removal.
  
Make sure the hood latch release cable is connected properly.
Make sure the hood locks/unlocks and opens/closes properly.
Adjust the latch alignment.
Hood Latch Components and components location
Component Location   1. Hood latch assembly ...

Tail Gate
...

Other information:

Kia Cee'd JD Service Manual: Troubleshooting
Troubleshooting   Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct ...

Kia Cee'd JD Service Manual: Repair procedures
Inspection Signal Circuit Inspection 1. Check clutch switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". (2) Disconnect clutch switch connector. ...

© 2017-2025 www.kceed.com