Kia Cee'd: Head Lamp Leveling Device / Head Lamp Leveling Switch Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Head Lamp Leveling Device / Head Lamp Leveling Switch Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the lower crash pad switch assembly (A) after loosening screws.

Inspection
1.
Remove the lower crash pad switch assembly.

2.
Connect the battery voltage to terminals 3 and the ground to terminal 4.
3.
Measure the voltage between terminals 4 and 2 at each position.
[Switch Position]
 
Position No.
Rotation
Voltage (V) (±5%)
0
0°
10.85
1
15°
9.78
2
30°
9.17
3
45°
8.55
4
60°
7.94
5
75°
7.32
6
90°
6.71

4.
If the voltage is not as specified, replace the head lamp leveling switch.
Schematic diagrams
Circuit Diagram ...

Auto Lighting Control System
...

Other information:

Kia Cee'd JD Service Manual: BJ Boot Components and components location
Components   1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing ...

Kia Cee'd JD Owners Manual: Seat belt warning
Driver’s seat belt warning (1) As a reminder to the driver, the seat belt warning light will illuminate for approximately 6 seconds each time you turn the ignition switch ON regardless of belt fastening. If the driver’s seat belt is unfastened after the ignition switch is ON, the sea ...

© 2017-2026 www.kceed.com