Kia Cee'd: Lift And Support Points / General information
|
When heavy rear components such as suspension, fuel tank, spare tire,
tailgate and trunk lid are to be removed, place additional weight in
the luggage area before hoisting. When substantial weight is removed
from the rear of the vehicle, the center of gravity may change and can
cause the vehicle to tip forward on the hoist.
|
| • |
Since each tire/wheel assembly weights approximately 14kg (30lbs),
placing the front wheels in the luggage area can assist with
the weight distribution.
|
| • |
Use the same support points to support the vehicle on safety
stands.
|
|
| 1. |
Place the lift blocks under the support points as shown in the illustration.
|
| 2. |
Raise the hoist a few inches (centimeters) and rock the vehicle to be
sure it is firmly supported.
|
| 3. |
Raise the hoist to full height to inspect the lift points for secure
support.
|
Other information:
Kia Cee'd JD Service Manual: Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting and test
procedure as follows. Compare the system condition with normal condition in
the table below and if abnormal symptom is detected, perform necessary remedy
and inspection.
&nb ...
: Changing the Format of the Map
Display the map in one of the following
formats:
A two-dimensional map with the
direction you are traveling toward the
top of the screen.
A two-dimensional map with north
toward the top of the screen.
A three-dimensional map with the
direction you are traveling toward the
front.
Zoom ...
Towing