Kia Cee'd: Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures

Kia Cee'd JD Service Manual / Body Electrical System / Fuel Filler Door / Fuel Filler Door Release Actuator Repair procedures

Removal

1.	Disconnect the negative (-) battery terminal.

2.	Open the tailgate and then remove the luggage side trim. (Refer to Body - "Luggage Side Trim")

3.	Disconnect the fuel filler door release actuator connector and remove the mounting nuts (2EA).

4.	Remove the fuel filler door release actuator (B) after removing the cable (A).

5.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Installation

1.	Install the fuel filler door release actuator cable.

2.	Install the fuel filler door release actuator.

3.	Connect the negative (-) battery terminal.

Components and components location

Components ...

Seat Electrical

...

Other information:

: Lane Keeping System Indicators
If you switch the lane keeping system on, a graphic with lane markings appears in the information display. When you switch the system off, the lane marking graphics do not display. Note: The overhead vehicle graphic may still display if adaptive cruise control is enabled. While the lane keepin ...

: Federal Highway Administration Regulation
Regulations such as those issued by the Federal Highway Administration or issued pursuant to the Occupational Safety and Health Act (OSHA), and state and local laws and regulations may require additional equipment for the way you intend to use your vehicle. It is the responsibility of the reg ...