Component Location |
1. Front pillar trim |
Kia Cee'd JD Owners Manual: Multi fuse
If the multi fuse is blown, it must be
removed as follows:
1. Turn off the engine.
2. Disconnect the negative battery cable.
3. Remove the fuse panel on the right
side in the engine compartment.
4. Remove the nuts shown in the picture
above.
5. Replace the fuse with a new one of the
s ...
Kia Cee'd JD Service Manual: Rain Sensor Repair procedures
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is ON then
both wiper low relay and wiper high relay outputs are controlled by
the rain sensor input signal.
2.
If the wiper switc ...